Search results

Problem: esptool.py error in v4.0.0 of erase.sh and install-fs.sh commands

Status: Open.

#1645 In bdring/FluidNC;

· pasantoro opened on Jan 9, 2026

Feature:

enhancementNew feature or requestNew feature or request

Status: Open.

#1640 In bdring/FluidNC;

· CRZD01 opened on Jan 4, 2026

Problem: Corgi CNC Controller not sending out signals to DM542

Status: Open.

#1638 In bdring/FluidNC;

· CMos75 opened on Jan 3, 2026

Problem: When parking, the wrong axle moves

Status: Open.

#1636 In bdring/FluidNC;

· DmiZar opened on Jan 3, 2026

Problem: Unable to setup FluidNC /communicate with Queenbee xPRO V5

Status: Open.

#1629 In bdring/FluidNC;

· alphonse1475-prog opened on Dec 17, 2025

Problem: Job crashes upon Wifi disconnect

Status: Open.

#1628 In bdring/FluidNC;

· f1adang opened on Dec 16, 2025

Problem: Modbus RS485 frame misalignment

Status: Open.

#1620 In bdring/FluidNC;

· ajmirsky opened on Dec 2, 2025

Problem: v4.0.0-pre2 WIFI mode AP ESP32 WEBUI3 timeouts

Status: Open.

#1618 In bdring/FluidNC;

· PhiJu5 opened on Nov 30, 2025

Problem: Spindel spinup_ms doesn't work

Status: Open.

#1617 In bdring/FluidNC;

· 20Jakob09 opened on Nov 29, 2025

Problem: Fluid Dial interferes with FluidNC when it runs gcode

Status: Open.

#1615 In bdring/FluidNC;

· eug3nix opened on Nov 24, 2025

Problem: Bad Defaluts for /uart?/passthrough_mode

Status: Open.

#1614 In bdring/FluidNC;

· dnikodem84 opened on Nov 24, 2025

Problem: The laser engraving grayscale card of the COREXY structure is experiencing lag.

Status: Open.

#1596 In bdring/FluidNC;

· junzilang383 opened on Oct 25, 2025