teletype_ARC_scenes

Some scenes to exemplify use of ARC specific OPs

see my teletype repository...


6 modes implemented.
Each ring can be set in a separate mode.
The Mode 0 is a bit special since it covers the Euclidean sequencer.
In this mode the TR outputs are internally connected to a ring.

Modes 1,2,3 are „only“ display/set value modes for any purpose.
You can set or get a ring value by SVAL or VAL. You can use it for any purpose in your scripts.
Display mode 1 is for Notes, mode 2 is for increasing values (means the ring lights will increase with VAL, and mode 3 for decreasing values.
Mode 4 and 5 are to configure the Euclidean pattern sequencer (length and phase).

Mode 0(Euclidean controller mode)
Mode 1(pitch display mode)
Mode 2(max Val display mode 0-64) - e.g. for slew rate, length or others
Mode 3(min Val display mode 0-64) - e.g. for Start of pattern or others
Mode 4(Euclidean Length configuration)
Mode 5(Euclidean Phase configuration)
OPs:

ARC.MO x y
This will change function or display of the rings.
x - Ring (1-4), 0 for all
y - set mode (0 Euclidean,1 Pitch, 2 Max Val, 3 Min Val, 4 config length, 5 config phase)

ARC.VAL x - set/get current value of ring x
x - Ring (1-4), 0 for all
y - Ring value (0-64)
following OPs are especially for Mode 0 (Euclidean Mode)

ARC.EUC x - get current euclidean value of ring x
x - Ring (1-4)

ARC.RST
reset/sync of all ring steps to 0

ARC.SYN x
1 on - all rings are synced [default] ; in EUCL Mode to the slowest (longest) ring
0 off

ARC.STP x
x - Next Euclidiean Step of ARC c, 0 for all

ARC.LEN x y
x - Ring (1-4) , 0 for all
y - length of pattern [default 16]

ARC.PHA x y
x - Ring (1-4), 0 for all
y - step / phase offset

ARC.SCR x y - start a script at Euclidean trigger, only in Mode (0)
x - Ring (1-4), 0 for all
y - Script (1-8)