.hex flash failure causes any subsequent flashes to fail

[hotstick]

Specifically when using Debug -> Load Hex:
During the custom program firmware test, Slow.hex loads and flashes correctly, Brick_Sending.hex flashes correctly, and Brick_Receiving.hex fails flashing (expected and a passed test). After loading the next cube to be tested however, I must completely reset Cubelet Studio and the BT before attempting to reflash Slow.hex, selecting doesn't flash or prompt the "Flashing..." status bar.

[programmarchy]

@ELundby45 would your addition of resetBluetooth/resetAll potentially fix this?

[ELundby45]

The resetBluetooth certainly helps reflashing after a failed flash for normal operation. However, I have observed that if any error occurs while doing Debug -> Load Hex, I'm unable to even start a flashing sequence.