Wirekit V1.1 Build Problems

[ericwhyne]

Model Issues:

1. Lower Idler holes on Front Base were too small for M5 screws. Had to be drilled out which made the reference surface that they run on smaller. Would be better if they were appropriately sized.
2. Tool Mount Cover is incompatible with Tool Mount. Mounting surface for the wago connectors on the Tool Mount has a draft angle which requires trimming the tool mount cover to allow it to fit.
3. Tool Mount required modification to fit onto the endoskeleton, the pocket designed to fit over the endoskeleton was too small and should be sized larger to enable a smoother fit.
4. Tool Mount required modification to allow the Top Front Base m5x16 mounting screws to be fully seated. The Back Lower Base had these seating recesses in the form of square pockets. These pockets need to be present on the Tool Mount also.

Documentation Issues:

1. Tension Arm Mount Screw is documented as being an M5x16, however this screw wasn't long enough. I used the extra M5x20 screw to hold on the idler arm.
2. Tension Arm Tension Screw installation is not documented. Easy to figure out, but missing entirely from documentation.