Failed to get patch semaphore

[adrium]

Hi, thanks for that project, it looks promising.
I just wanted to setup a HP Laptop 15-fd1xxx which contains the mt7902.

With Ubuntu Kernel 6.11.0-14-generic, the tree in mt76_new/mt7902 compiles cleanly and the module can be loaded successfully. However, the device can not be started:

mt7902 0000:02:00.0: enabling device (0000 -> 0002)
mt7902 0000:02:00.0: ASIC revision: 79020000
mt7902 0000:02:00.0: sar cnt = 0
mt7902 0000:02:00.0: Message 00000010 (seq 1) timeout
mt7902 0000:02:00.0: Failed to get patch semaphore
mt7902 0000:02:00.0: Message 00000010 (seq 2) timeout
mt7902 0000:02:00.0: Failed to get patch semaphore
mt7902 0000:02:00.0: Message 00000010 (seq 3) timeout
mt7902 0000:02:00.0: Failed to get patch semaphore
mt7902 0000:02:00.0: Message 00000010 (seq 4) timeout
mt7902 0000:02:00.0: Failed to get patch semaphore
mt7902 0000:02:00.0: Message 00000010 (seq 5) timeout
mt7902 0000:02:00.0: Failed to get patch semaphore
mt7902 0000:02:00.0: Message 00000010 (seq 6) timeout
mt7902 0000:02:00.0: Failed to get patch semaphore
mt7902 0000:02:00.0: Message 00000010 (seq 7) timeout
mt7902 0000:02:00.0: Failed to get patch semaphore
mt7902 0000:02:00.0: Message 00000010 (seq 8) timeout
mt7902 0000:02:00.0: Failed to get patch semaphore
mt7902 0000:02:00.0: Message 00000010 (seq 9) timeout
mt7902 0000:02:00.0: Failed to get patch semaphore
mt7902 0000:02:00.0: Message 00000010 (seq 10) timeout
mt7902 0000:02:00.0: Failed to get patch semaphore
mt7902 0000:02:00.0: hardware init failed

Can I help with any debugging?

[OnlineLearningTutorials]

yes, you can help by debugging
check my dmesg of mt7902
and the whole dmesg of mt76
Failed to get patch semaphore means the firmware have no signal that it can be loaded to mt7902 chip there may be some address incorrect of that of mt7921, but that's not only problem if we place the firmware on the device than we are not sure that all functioning is correct, it will be best if mediatek give some advice or datasheet of mt7902 chip. But if you want to try than try

[adrium]

I am not familiar with kernel development, so I do not know how to interpret the dmesg text files.
But have access to the laptop occasionally. You can let me know some commands to run or new code to compile, if that helps.