Input after config broken on macOS

[enjikaka]

Thanks for this really cool project. This actually takes my 200 kr (~20 USD/EUR) cheap speakers to a whole new level!

Ran into this issue though. After I've choosen sound in/outputs and sample rate I'm left with

LCC ON... press 1 to turn LCC on, 2 to turn LCC off, 3 to change settings, 4 to quit.

but from here on the program does not accept any keyboard input. Typing 1, 2, 3 or 4 does nothing.

Whole command line output if needed;

./lcc
./rt_lcc {inputgain} {centergain} {endgain} {LCC_Decaygain} {LCC_Delay_in_microseconds}
version 0.8
Did not receive 6 arguments. Using defaults: ./lcc -3 -3 3 -2.5 32
0:Apple Inc.: DELL P2715Q, rates:32000,44100,48000,88200,96000
1:Apple Inc.: Built-in Microphone, rates:44100,48000,88200,96000
2:Apple Inc.: Built-in Output, rates:44100,48000,96000
3:ma++ ingalls for Cycling '74: Soundflower (2ch), rates:44100,48000,88200,96000,176400,192000
4:ma++ ingalls for Cycling '74: Soundflower (64ch), rates:44100,48000,88200,96000,176400,192000
Select Input Device: 3
Select Output Device: 0
Select Sample Rate: 44100
input gain: 0.700000
center channel gain: 0.700000
LCC decay gain: 0.749894
LCC delay in us: 32.000000
LCC delay in samples: 1.411200
Debug only: delaymod: 0.588800
Debug only: delaymodinv: 0.411200
Debug only: bufferframes: 2048

LCC ON... press 1 to turn LCC on, 2 to turn LCC off, 3 to change settings, 4 to quit.

[LionsAd]

FWIW - input when run from Terminal works fine for me, but I had to recompile it, too.